|
IMGP0465
Top view of Deck showing o-rings, notching and stud setup.
Date: 23/06/09
Owner: hiy_po
Views: 55
|
IMGP0459
Top view of Deck showing o-rings, notching and stud setup.
Date: 23/06/09
Owner: hiy_po
Views: 41
|
IMGP0457
Closer look at the deck modifacations.
Date: 23/06/09
Owner: hiy_po
Views: 71
|
|
IMGP0463
closer look different angle
Date: 23/06/09
Owner: hiy_po
Views: 59
|
100_0732
This pic shows the copper head gasket after it has been prepped to fit. It was annealed first then given a heavy coat of copper spray
Date: 30/08/09
Owner: hiy_po
Views: 28
|
100_0733
prepped head gasket diffrant view
Date: 30/08/09
Owner: hiy_po
Views: 28
|
|
100_0734
Dialing in a cam isnt hard. The camcard that comes with the cam will usualy show the lift @ TDC in my case its 0.039 @ TDC. I use 2 dial gauges with magnetic bases and a solid lifter fitted to N0:1 intake.
Date: 30/08/09
Owner: hiy_po
Views: 26
|
100_0735
The gauge reading N0:1 piston is set to zero at the beggining of TDC. The other dial gauge reads the lift of the lifter sitting on the intake lobe of number 1. This gauge is set to zero with the lifter sitting on the back of the lobe ie no lift.
Date: 30/08/09
Owner: hiy_po
Views: 27
|
100_0736
Gauge shows zero at the beggining of TDC
Date: 30/08/09
Owner: hiy_po
Views: 22
|
|
100_0737
Dial shows 0.039 at the beggining of TDC
Date: 30/08/09
Owner: hiy_po
Views: 28
|
100_0739
Adjustable timing gears are a must. Its not often a cam is correct with std gears. As you can see this cam needed to be set -2 to get the correct reading
Date: 30/08/09
Owner: hiy_po
Views: 46
|
|
